Environmental Notice - Braun micron vario 3520 Manual Del Usuario

4 Keeping your shaver in top shape
4.1 Cleaning
• After shaving, switch the shaver off. Remove the foil frame
out on a flat surface.
• Then thoroughly clean the cutter block with the brush. About every four weeks,
clean the cutter block with Braun cleaning agents.
• Do not clean the shaving foil with the brush.
• If you have a very dry skin and you notice a reduced operation time of the shaver,
you should put a drop of sewing machine oil onto the shaving frame.
• Put on the foil protection cap to protect the foil and to prevent the shaver from
accidentally switching on, especially when travelling.
4.2 Changing the shaving parts
• To maintain optimum shaving performance, we recommend to replace the shaving
frame and the cutter block every 1 1/2 year or when these parts are worn.
• Take out or replace the foil frame only after having removed the shaving head from
the shaver. To remove the foil frame, firmly press both release buttons sumultane-
ously until the foil frame comes away from the shaving head, and lift it off (e). Handle
the foil frame carefully to avoid damaging the foil. When replacing the foil frame,
carefully press it into the shaving head until it clicks into position.
• To remove the cutter block, set it in crosswise position and lift it off (f).
To replace the cutter block, snap onto the holding studs.
4.3 Preserving the cell unit
• In order to maintain the capacity of the cell unit, the shaver has to be discharged by
shaving every 6 months approximately. Then recharge the shaver to full capacity
again.
• Do not expose the shaver to temperatures of more than 50 °C for longer periods of
time.

5 Environmental notice

This appliance is provided with a nickel-hydride cell unit.
This cell does not contain any harmful heavy metals. Nevertheless, please
do not dispose of this appliance in the household waste at the end of its
useful life. Disposal can take place at a Braun Service Centre or appropri-
ate collection sites. However, if you prefer to dispose of the cell unit
yourself, remove the cell unit as shown on page 40.
Subject to change without notice.
This product conforms to the EMC-Requirements as laid down by the
Council Directive 89/336/EEC and to the Low Voltage Regulation
(73/23 EEC).
4
(d) and gently tap it
7