Toto EcoPower Manual De Instrucciones página 13

INSTALLATION PROCEDURE — SMALL COVER
12. Connect the battery cable with the
controller and set the battery in place.
13. Attach the vandal proof screws the
front cover using washers.
14. Connect the cables of infrared sensor
and controller with the connection cable.
15. Connect the cables of manual button
and controller with the connection cable.
NOTE: It will take 5 minutes after connecting the
battery for the electronics to initialize.
After approximately 30 seconds, the
sensor LED will flash in 4 second intervals
until the initialization completes.
16. Before the supply water is turned on, be
sure all water leaks are eliminated by
tightening all the pipe connections.
NOTE: If for any reason it becomes necessary to
remove the control stop, make sure the
water is shut off at the main supply valve.
17. Fasten the front cover to the base frame
by tightening the screws with the
supplied hex wrench.
18. Take care so that any cord, wire or chain
might not be caught between the front
cover and the box.
Battery
Controller
Connection cable
Washer
13
Screw
Connection cable
(button)
Connection cable
(sensor)
Hex wrench