Publicidad
Step 9
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the END (A) until the shoulders of the SCREWS rest on the
å
surfaces of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (J and K) onto the END (A). Line up the grooves in the MOLDINGS over the heads of the SCREWS in
å
the END.
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Repeat this step for the remaining END.
å
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
BLACK 9/16" FLAT HEAD SCREW
(8 used in this step)
J
A
32S
These edges
should be even.
K
Page 15
Publicidad
