Tabla de contenido
Publicidad
Step 17
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the right diagram. If it isn't, loosen the
mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the DOOR (T) to the END (A) as shown in the lower diagram.
å
Use the screws in the HINGES. You should start each SCREW a few turns
before completely tightening any of them.
Fasten a PULL (22K) to the DOOR (T). Use a WASHER (10I) and a
å
SILVER 1/4" MACHINE SCREW (61S).
Peel two FELT DISKS from the FELT DISK CARD (1M) to the DOOR (T) where it
å
comes in contact with the LARGE UPRIGHT (O).
Repeat this step for the other DOOR (T).
å
See the next step for DOOR adjustments.
å
O
SILVER 1/4" MACHINE SCREW
(2 used in this step)
Stop
Mounting
screw
A
61S
Pro Tip: Lift with your
legs. And, you know,
your arms.
Hinge
22K
T
10I
1M
Page 23
Publicidad
Tabla de contenido
