Instructions For Operating Devices; General Notes - ULTIMATE SPEED USSW 300 B2 Instrucciones De Funcionamiento Y De Seguridad

Instructions for operation
4
switch to the "1" (ON)
position. You will hear a short
beep and the overload display
3 (red) lights up briefly. After
that the operating LED
(green) lights up, if the car
power inverter
connected to a charged
battery.
Now switch on the load/
„
device to be operated.
Note:
If you hear a beep and the
overload display
the input voltage is too low, or
output of the load/device con-
nected to the car power inverter
1
is too high.
z Instructions for
operating devices

General notes:

Information about the power
consumption in Ampere (A) or the
power draw in Watt (W) is usually
shown on the rating plate of
22 GB/IE/NI/CY/MT
2
1
is properly
3 lights up red,
devices. Before using the device,
please make sure that the maxi-
mum current draw is not higher
than 1.30 A and the maximum
continuous output is not more than
300 W.
Loads with a high internal
„
resistance can be operated
very effectively using the car
power inverter
loads with a low internal
resistance, such as, for
example, heating and cooking
devices, generally have a
power draw in Watt which is
too high.
Inductive loads such as, for
„
example, televisions or stereo
devices (devices with a coil or
a transformer) often require a
start-up current which is many
times higher than resistive
loads with the same given
power draw in Watt. When
switching on, televisions
require a power draw which is
many times higher than the
value given on the rating plate.
1
, whereas