Signal If The Battery Voltage Is Low; Charge Usb Device; Replacing The Fuses - ULTIMATE SPEED USSW 300 B2 Instrucciones De Funcionamiento Y De Seguridad

Because of this you may need
to switch the car power
1
inverter on and off several
times, in order to be able to
switch a television on.
If you have any doubts, please
„
contact the manufacturer of the
connected device.
z Signal if the battery
voltage is low
If the battery voltage sinks
„
below 10.5 V, the car power
inverter switches off
the overload display
up red. A warning beep
sounds.
z Charge USB device
Attention!
Before connection, make sure
that the current draw of the USB
device is not higher than 1A. For
more detailed information, please
refer to the operating instructions
for your USB device.
Plug the USB plug of the USB
„
device to the USB connection
If necessary, switch the USB
„
device on.
Note: The 230 V socket
the USB connection
used at the same time.
z Replacing the fuses
1 and
3
lights
Before replacing the fuse,
disconnect the car power inverter
1
from the power supply. Also
remove any device connected to
the car power inverter
Replace the fuse with one of equal
value with the same cut-off char-
acteristics (20 A), as given in the
technical specifications.
Instructions for operation
6
of the car power inverter
1 .
6
Danger to life
through electric
shock!
GB/IE/NI/CY/MT
5
and
can be
1
.
23