Connection Example - Toa WTU-M9800 Manual De Instrucciones

5. NOMENCLATURE
1. Antenna input A, B
75 Ω, BNC
When external antennas are not required, use the supplied two rod antennas,
which should be set at a 45° angle from vertical. If external antennas are
required, please use the optional YW-4500 powered antenna.
2. Reception lamps
Either lamp of A (left) or B (right) lights green when the tuner module receives a
radio signal.
3. Channel selector switch
Set the receiving channel.
4. Contact output terminal
Push-type terminal block. CC is closed when unit receives RF from the
transmitter
5. DC input jack (* External power supply mode only)
Connect the power cable of the optional AC adapter to this
internal jumper settings are correct.
6. Jumper connector for power supply mode select
Select the internal or external power supply
⑥
6. CONNECTION
6.1. Plug-in module insertion
Step 1. Remove the blank panel covering the module slot on
the rear panel of the equipment.
Step 2. Align the module board with the top and bottom
guide rails, and press in.
Step 3. Using the screws supplied with the module, secure
the module to the rear panel.

6.2. Connection example

Be sure to connect at least two receiving antennas (one each for Antenna A and B).
* External power
supply mode only
AC adapter or
equivalent power
supply source *
2
jack. Make sure
mode.
Accessory
2
3
4
5
Wall-mounted
wireless antenna
or
YW-4500 (option)
1