Publicidad
Idiomas disponibles
Idiomas disponibles
11. Your clamps can be partially pre-assembled.
The clamp assembly that mounts to your unit may be
oriented horizontally or vertically.
T he preferred orientation of the clamp assembly is to have the saddles
perpendicular to one another. Thread the small bolt P into the center of
K and L assemblies, finger-tight. Slide smaller tube, L, into larger tube, K.
12. T o determine the general location and direction for the crossbar (J), have
an assistant hold the cab at the desired location over the unit.
NOTE: Depending on your unit, the crossbar may be
positioned facing forward or backward, and above
or below any linkage.
13. N otice how crossbar will sit in clamp assemblies once clamps are mounted
on unit.
NOTE: If the controls on your snow blower require more space for proper
operation, flip bar J.
14. H olding crossbar (J) in desired location, select area to mount K and L clamp
assemblies. See Fig. 12.
NOTE: Brute
®
and John Deere
horizontal handlebars on the unit.
NOTE: Preferred position is on the vertical portion of the unit's upper
handlebars.
6
®
units may require you to mount to the
Lower Handle Bars
(Horizontal Tube Mount)
K
L
Backward
OR
Forward
Facing
Upper Vertical
Handle Bars
K
Upper Handle Bars
(Vertical Tube Mount)
OR
Facing
Lower Horizontal
Handle Bar
L
K
J
K
OR
L
J
K
P
K
L
Crossbar (J)
L
L
Publicidad
