Mr Coffee Pod + Manual Del Usuario página 12

Problem Possible Cause
The filter The carafe is not
basket
placed all the way
overflows
on the platform
Too many coffee
grounds were
placed in the filter
The carafe was
removed from the
platform for more
than 30 seconds
The coffee is
There's a power
not hot
outage
Coffee grounds
The coffee
other than for an
tastes bad
automatic drip
coffeemaker were
used
The ground coffee-
to-water ratio was
unbalanced
The coffeemaker
needs cleaning
E22
BVMC-SS12XTH_21ESM1.indd 22-23 BVMC-SS12XTH_21ESM1.indd 22-23
Solution
Place carafe correctly on
platform
Remove filter discard
grounds. If paper filter,
replace. If permanent
filter, rinse. Begin
brewing process again
Turn off and unplug the
unit. Allow to cool. Wipe
up the spill.
Wait for power to be
restored
Use coffee grounds
recommended
for automatic drip
coffeemakers
Adjust the ground
coffee-to-water ratio to
suit your taste
Clean coffeemaker as
described in "Routine
Cleaning" section
Problem Possible Cause
The Brew The Pod Holder
Basket will not is not inserted
slide into the correctly.
unit.
"No Water" is
There is no water in
flashing on the
the water reservoir.
display.
When the
"Add Water"
machine's pump
sign with a full
is not used for an
reservoir is
extended period
flashing on the
of time, it needs
display.
to run longer on
initial use before it
recognizes water is
flowing.
Solution
Set the Pod Holder
inside the Brew Basket
so that it sits flat and
the sensor should be
pointing away from the
front.
Fill the water reservoir
with fresh, cold water to
the desired water level
up to the MAX line.
1. Unplug coffeemaker.
2. Plug in the
coffeemaker.
3. Press STRONG and
MIN buttons at the
same time for 5
seconds. You will hear
a beep.
4. Wait 30 seconds.
5. Coffeemaker is now
ready for use.
E23
2021/8/11 上午9:55 2021/8/11 上午9:55