Restore Factory Settings - Roborock S7 Manual Del Usuario

Instructions
Charging
The robot will return to the charging dock automatically after fin-
ishing. If it is paused, press the
ing dock. The power indicator will breathe as the robot charges.
Note: If the robot cannot find the charging dock, it will return to the most recent starting
location. Place the robot on the charging dock manually to recharge.
Error
If an error occurs, the power indicator flashes red quickly, and a
voice alert sounds. See "Errors" for solutions.
Note:
• The robot will automatically enter Sleep mode if left in an error state for over 10 minutes.
• Placing the robot on the charging dock in an error state will stop the current cleanup.
System Reset
If the robot does not respond to button presses or cannot be
turned off, reset the system. The robot will then restart.
Note: After a system reset, cleaning schedules, WiFi, and other settings will be restored to
factory settings.

Restore Factory Settings

If the robot is not functioning after a system reset, turn it on. Press
and hold the button and at the same time press Reset button
until you hear the "Restoring the initial version" voice prompt. The
robot will then be restored to factory settings.
button to send it to the charg-
Selective Room Cleaning
The robot will clean the areas selected in the app.
C
A
Note:
• Map Saving mode must be switched on, and a full clean completed before this function can
be used.
• The robot may enter unselected areas during cleaning. Clear obstacles from the ground
around the selected rooms as the robot may enter these areas.
Zone Cleaning
The robot will clean the Zone(s) drawn in-app.
Note: While cleaning the designated zone, the robot may move outside zone borders. Make
sure that there are no cables or obstacles placed close to the cleanup zone.
025
D
B