Yakima WaveHog Manual Del Usuario página 2

Position SoulPads on crossbars.
Place the SoulPads on your crossbars orientated as shown.
If your vehicle has an adjustable crossbar system, you
must use the maximum possible crossbar spread when
carrying long loads. Do not move your Q-Towers!
Secure SoulPads with pad straps.
a
fuzzy
side
FRONT OF
VEHICLE
For Vehicles with wide crossbars...
b
Install S.U.P. Brah assembly to longest board.
Place short red tie-downloop
around nose of board.
If your board has fins be sure the loops clear the fins to avoid damaging them.
1033507B-2/18
With fuzzy side facing
front of vehicle put pad
straps under crossbar
and up through holes
of SoulPad, then
through buckle.
FRONT OF
VEHICLE
With fuzzy side facing rear
of vehicle put pad straps
under crossbar and up
through holes of SoulPad,
then through buckle.
NOTE: Be sure
flat side of buckle
faces downward.
Push buckle completely
under SoulPad and towards
the rear of the crossbar.
Push buckle completely under SoulPad
and towards the rear of the crossbar.
FRONT OF VEHICLE
While keeping
buckle in place pull
strap end up and
into place as shown.
While keeping
buckle in place pull
strap end over and
into place as shown.
Place long red tie-down loop
around tail of board.