Yakima WaveHog Manual Del Usuario página 5

Install both RipCords.
Loop RipCord strap under far side of
crossbar. Bring strap over board, and
under near side of crossbar.
Push and
hold button,
then thread
strap through
underside, and
out the front of
RipCord lock.
Adjust protector tubes, tighten S.U.P. Brah Straps.
Lock RipCords.
1033507B-5/18
If you have loaded multiple boards RipCord is to be installed around all boards.
To avoid damage to your vehicle's finish
slide plastic tube to cover areas where
strap comes in contact with vehicle.
Pull strap ends to tighten. Secure extra
strap if necessary.
Pull strap end to tighten Ripcord down.
Gather extra strap and secure it.