Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Symbols and Annunciators
V
A
AC
DC
-
•)))
F
Hz
°F
°C
AUTO
HOLD
PMAX
PMIN
MAX
MIN
n
µ
m
k
M
OL
12070T
Volts
Amps
Alternating Current
Direct Current
Display minus sign
Ohms
Continuity
Diode test
Farad (capacitance)
Hertz (frequency)
Degrees Fahrenheit
Degrees Centigrade
Autoranging
Display hold
Auto Power Off
Peak maximum
Peak minimum
Maximum record
Minimum record
Low battery
nano (10
)
-9
micro (10
)
-6
milli (10
)
-3
kilo (10
)
3
mega (10
)
6
Overload
7
Operation
AC and DC Voltage
WARNING:
Observe all safety precautions when working on live voltages.
1. Set the rotary function switch to the V position.
2. Momentarily press the MODE button
to select AC or DC voltage. "AC" or "DC"
will appear on the LCD display.
3. Insert the black test lead into the
negative COM input jack and the
red test lead into the positive V input jack.
4. Touch the test probe tips in parallel to
the circuit under test. For DC measurements,
touch the red test probe to the positive side
of the circuit and the black test probe to the
negative side of the circuit.
5. Read the voltage on the LCD display.
AC and DC Current Measurements
WARNING:
Observe all safety precautions when working on live circuits.
Do not measure current on circuits that exceed 1000V. Measurements
in the 10A range should be limited to 30 seconds max. every 15 minutes.
1. Insert the black test lead into the negative COM input jack.
2. For current measurements up to 10A, set the rotary
function switch to the 10A position and insert the red
test lead into the positive 10A input jack.
3. For current measurements up to 400mA, set the
rotary function switch to the mA position and insert
the red test lead into the positive mA input jack.
4. For current measurements up to 4000µA, set the
rotary function switch to the µA position and insert
the red test lead into the positive µA input jack.
5. Momentarily press the MODE button to select AC or DC
current. "AC" or "DC" will appear on the LCD display.
6. Remove power from the circuit under test, then open
up the circuit at the point where you wish to measure
current.
®
12070T
Autoranging Multimeter
Waterproof
Auto Power Off
10A
CAP
Hz
Temp
!
30 sec MAX
CAT III 1000V
every 15 min
CAT IV 600V
FUSED
COM
mA
MAX 400mA
®
12070T
Autoranging Multimeter
Waterproof
Auto Power Off
CAP
10A
Hz
Temp
!
30 sec MAX
CAT III 1000V
every 15 min
CAT IV 600V
FUSED
COM
mA
MAX 400mA
8
LOAD
V
A
Publicidad
Tabla de contenido
