Max/Min Button; Backlight Button - Southwire 12070T Instrucciones De Uso

Multímetro true rms
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
MODE Button
To select /Diode Test/Continuity, AC/DC Voltage, AC/DC Current.
HOLD Button
To freeze the reading on the LCD display, momentarily press the HOLD button.
The "HOLD" icon will be displayed on the LCD. Momentarily press the HOLD
button again to return to normal operation.
RANGE Button
When the meter is first turned on, it goes into the Autoranging mode.
This automatically selects the best range for the measurements being made
and is generally the best mode for most applications. For measurement
situations requiring that a range be manually selected, perform the following:
1. Press the RANGE button. The "AUTO" display indicator will turn off.
2. Press the RANGE button to step through the available ranges until you select
the range you want.
3. Press and hold the RANGE button for 2 seconds to exit the Manual Ranging
mode and return to Autoranging.

MAX/MIN Button

The MAX/MIN function allows the meter to capture the highest and lowest
measurement for later reference. (MIN/MAX is limited to a single range.)
1. Use the RANGE button to select the proper range for the measurement
being made.
2.Press the MAX/MIN button. The indicator "MAX" or "MIN" will appear
in the display.
3. Press the MAX/MIN button to recall the lowest or highest reading.
4. If the "MAX MIN" message is flashing, the instrument is in MAX/MIN mode
but not recording, press the MAX/MIN button to select a mode.
5. To return to normal AUTO measurement mode, press and hold the
MAX/MIN button for 2 seconds.
5
Operation
PEAK Hold button
The Peak Hold function captures the peak AC or DC voltage or current.
It can capture negative or positive peaks as fast as 1 millisecond in duration.
1. Refer to the manual for Voltage or Current measurements.
2. Connect to the circuit under test.
3. Allow time for the display to stabilize.
4. Press and hold the PEAK button until "CAL" appears on the display.
This procedure will zero the range selected.
5. Press the PEAK button, Pmax will display.
6. The display will update each time a higher positive peak occurs.
7. Press the PEAK button again, Pmin will display.
8. The display will update each time a higher negative peak occurs.
9. To return to normal operation, press and hold the PEAK button until the
Pmin or Pmax indicator switches off.

Backlight Button

The backlight illuminates the display when the ambient light is too low to permit
viewing of the displayed readings. To turn on the backlight, press the " " button.
Auto Power Off
In order to conserve the battery, the meter will turn off approximately after
30 minutes of use. To override Auto Power Off, press and hold the PEAK button
with the function switch in the OFF position. Turn the function switch to turn
the meter on. Release the PEAK button. The
will not be shown; indicating the Auto Power Off is not activated.
To re-activate Auto Power Off, turn the function switch to the OFF position.
The
symbol will be shown on the LCD display when the meter is turned on.
symbol on the LCD display
6

Publicidad

Tabla de contenido
loading

Tabla de contenido