DeWalt D26420 Manual De Instrucciones página 23

• Place the other sanding pad onto the base
aligning the screw holes.
• Replace the screws (11) and tighten them.
Adjusting the front handle (fig. D)
The position of the front handle can be adjusted for
optimum control.
• Loosen the knob (13) located in the centre of the
front grip (4).
• Take the handle from the tool and place it on
either mounting position.
• Make sure that the handle is placed correctly.
• Tighten the knob.
D26420/D26422 - Setting the electronic speed
control dial (fig. A)
The speed is infinitely variable from
12,000 - 22,000 min -1
control dial (3).
• Turn the electronic speed control dial to the
required level. The correct setting, however,
is a matter of experience.
• Generally, harder materials require a higher setting.
Dust extraction (fig. E)
Since woodworking with a sander
produces dust, always install a dustbag
designed in compliance with the
applicable directives regarding dust
emission.
Do not use a dustbag or vacuum
extractor without proper spark protection
when sanding metal.
• Fit the dustbag (8) into the frame (7) as shown.
• Attach the frame (7) to the dust extraction outlet
(14).
• Turn the assembly clockwise to lock it in position.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Make sure all materials to be sanded are
well secured.
using the electronic speed
• Apply only a gentle pressure to the
workpiece. Excessive pressure does not
improve the sanding effect, but only
results in an increased load on the
machine and causes the abrasive to tear.
• Avoid overloading.
Do not sand magnesium!
Switching on and off (fig. A)
• Switching on: press the on/off switch (1).
• For continuous operation, also press the lock-on
button (2).
• Switching off: press the on/off switch again.
Sanding (fig. A)
• Start with the coarsest grit size.
• As the tool produces small scratch marks in all
directions, it is not necessary to sand with the
grain.
• Check your work at short intervals.
• Always switch off the tool when work is finished
and before unplugging.
Replacing the dustbag (fig. E)
For efficient dust extraction replace the dustbag
when it is about one third full.
• Carefully pull the dustbag opening (15) off the
frame outlet (16) and remove the dustbag (8).
• Fit a new dustbag following the instructions as
described above.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
E N G L I S H
23