Battery Removal - Remington Comfort Serie Manual Del Usuario

ENGLISH
• Lubricate the teeth of the trimmer every six weeks with a drop of sewing machine oil.
• Note: the shaver headguard has been designed so that when placed on the shaver
head, the shaver can be stood on the headguard to allow any water droplets to drain
from the shaver head.
REPLACING THE FOILS AND CUTTERS
• To ensure continued high quality performance from your shaver, we recommend the
foils and cutters are replaced regularly.
• Signs that your foil/s and cutter/s need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
• Pull the foil assembly up to remove from the hair pocket.
• Insert the new foil assembly on the hair pocket, press down and click into place.
REPLACING THE CUTTERS
• Grasp the cutter between your thumb and forefinger and pull upwards.
• Snap the new cutter into the oscillator tip.
• Note: DO NOT press on the cutter ends as this may cause damage.
• Foil and cutters replacement model: SPF-PF

BATTERY REMOVAL

We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Remove 2 screws from the end cap. Remove the end cap and main housing from the
back.
2. Using a small screwdriver, pry off the rear housing.
3. Remove 6 screws and then open the inner cover from the shaver to expose the battery.
4. Cut the tabs which connect the battery to the circuit board and remove the battery.
• The battery is to be disposed of safely.
6