Traxxas TRX4 SPORT Instrucciones De Instalación

Snorkel and Side Mirrors Installation Instructions
Tools needed:
• Tapered body reamer
• Hobby knife
Installation
1. Install the included templates on the truck body. Align the arrows with the side
windows and body lines as shown in Fig. A.
2. Using a tapered body reamer (part #3433 or #3433X, sold separately), carefully cut the holes in the truck body for the side mirrors (note the hole diameters
indicated on the templates and the corresponding diameter measurements on the body reamer).
3. Using a hobby knife, cut the slot in the truck body for the upper snorkel retainer.
4. Assemble the snorkel using the included 2.6x8 BCS (3) (Fig. B).
5. Insert the upper snorkel retainer through the slot in the truck body.
6. Install the right side mirror. Push the upper peg of the mirror through the hole in the snorkel retainer.
7. Install the left side mirror; then, secure both mirrors and snorkel with the included o-rings and body clips as shown in Fig. B.
8. Install the lower snorkel retainer with the 2.6x12mm BCS (1) (Fig. B).
Fig. A
Slot for upper
snorkel retainer
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
CAUTION: RISK OF INJURY!
Use care with hobby knives, tapered reamers, and other
cutting tools as they are extremely sharp and can cause
severe injury, deep cuts, and/or punctures.
Fig. B
7943
2.6x8 BCS
7943
2.6x8 BCS
Upper snorkel
retainer
Lower snorkel
retainer
T R A XXA S. com
Tapered Body Reamer
Diameter Measurements
8299
2.6x12 BCS
Covers Parts #8119
KC2692-R04 190117