Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Screens and symbols
Bluetooth®
• When the Bluetooth® symbol blinks,
ConnexxLink is connecting to the
Bluetooth® dongle.
• When the Bluetooth® symbol is constantly
showing, ConnexxLink is connected to the
Bluetooth® dongle.
full
Battery status
• Charge ConnexxLink when the battery is
low
turning low.
empty
charging
Device ready
Ready for data transfer
Data transfer error
• shown for a few seconds, then switches back
to "Ready for data transfer".
Data transfer ok
• shown for a few seconds, then switches back
to "Ready for data transfer".
• while data is transferred no symbols are
shown on the screen.
10
Maintenance and care
Cleaning
Note: Do NOT put in water! Do NOT clean with alcohol
or benzine.
• Clean ConnexxLink as necessary with a soft tissue.
• Avoid abrasive cleaning liquids with additives such as
citric aids, ammonia, etc.
Technical information
Operating frequencies: Fc=3.28 MHz
CE, FCC and IC compliance information can be found inside the
battery compartment.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority
to operate the equipment.
Siemens ConnexxLink
FCC: SGI-WL200AP
This Class B digital apparatus II radiocommunication device
complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause interference.
(2) this device must accept any interference, including
interference that may cause undesired operation of
the device.
11
Publicidad
Tabla de contenido
