Connecting Speakers Or Other Audio Receivers; Connecting To The Internet Through A Wireless (Wifi) Device - Hisense 40H4C1 Manual Del Usuario

Connecting Devices to Your TV

Connecting speakers or other audio receivers

To connect speakers or other audio receivers with an audio cable (not provided):
1. Use an audio cable to connect the digital audio in port of the audio receiver device to the DIGITAL AUDIO OUT port of the
TV. Another option is to use an RCA Y-cable (1/8"-stereo mini to L/R phono) to connect analog sound system to the AUDIO
OUT port of the TV.
2. Plug the connected devices into the main socket before switching on the TV.
TV PORTS
DIGITAL
AUDIO OUT
/
AUDIO OUT

Connecting to the Internet through a Wireless (WiFi) Device

This section shows how to establish a wireless Internet connection for your TV.
Our built-in wireless LAN adapter supports the IEEE 802.11 b/g/n communication protocols and we recommend that you use
an IEEE 802.11n router. When you play a video over an IEEEE 802.11 b/g connection, the video may not play smoothly.
NOTES
• You must use the Hisense built-in Wireless LAN Adapter to use a wireless network because the TV does not support an
external USB network adapter.
• To use a wireless network, your TV must be connected to a wireless IP sharer. If the wireless IP sharer supports Dynamic
Host Configuration Protocol (DHCP), your TV can use a DHCP or static IP address to connect to the wireless network.
• Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer is
currently being used by another device nearby, this will result in interference and communication failure.
• If you apply a security system other than the systems listed below, it will not work with the TV.
• If Pure High-throughput (Greenfield) 802.11N mode is selected and the Encryption type is set to WEP, TKIP or TKIP-AES
(WPS2 Mixed) for your Access Point (AP), then the Hisense TV will not support a connection in compliance with these
Wi-Fi certification specifications.
• If your access point (AP) supports Wi-Fi Protected Setup (WPS), you can connect to the network via Push Button
Configuration (PBC) or PIN (Personal Identification Number). WPS will automatically configure the SSID.
Audio Cable
Red(R)
Audio Cable
White(L)
Wireless Adapter
built-in the TV set
EXTERNAL DEVICES
Digital Sound Bar
Powerless
Audio Amplifier
Bass Speaker
Wireless Wi-Fi device or
Wireless IP sharer
LAN Cable
5
Speaker
The LAN Port on the Wall