Care and Cleaning
WARNING
- Electrical Shock Hazard
• Disconnect power supply before servicing.
• Replace all parts and panels before operating.
• Failure to do so can result in death or electrical shock.
WARNING
- Shock Hazard
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing.
Service personnel – DO NOT contact the following parts while the appliance is energized: Electrical Valve, Drain
Pump, NTC, Motor Control Unit.
Exterior of the Washer
Immediately wipe off any spills with a damp cloth.
Interior of the Washer
To clean the interior of the washer, select the Whites cycle
and Deep Fill option on the control panel. A basket clean
cycle should be performed, at a minimum, once per month.
This cycle will use more water, in addition to bleach, to control
the rate at which soils and detergents may accumulate in your
washer.
NOTE: Read the instructions below completely before starting
the basket clean cycle.
1. Remove any garments or objects from the washer and
ensure the washer basket is empty.
2. Open the washer lid and pour 1/2 cup or 125 ml
of liquid bleach or other washing machine
cleaner into the basket.
Lint Filter
Clean EVERY MONTH to remove any items that may have
been caught in the filter.
1. Remove the blue lint filters from the side of the basket by
unclipping.
2. Open the filter, gently remove lint, rinse filter in warm water,
and close.
3. Replace by snapping filter back into its location in the
washer basket.
49-90587
3. Close the lid, select the Whites cycle, and the Deep Fill
option. Push the Start button.
4. When the basket clean cycle is working, the display will show
the estimated cycle time remaining. Do not interrupt the cycle.
If interrupted, be sure to run a complete basket clean cycle
before using the washer.
IMPORTANT:
Run this cycle with 1/2 cup (125 ml) of bleach once a month.
After the completion of a basket clean cycle, the interior of
your washer may have a bleach smell.
Push top down
and pull out
11