GE GFXP1308FWW Instrucciones De Instalación

I stollation
I structi
Pedestal
White Pedestal: GFXP1308FWW
Red Pedestal: GFXP1308FRR
Metallic Carbon Pedestal: GFXP1308FMC
For Washer Models:
GFWS2500, GFWS2505, GFWS2600, GFWS2605,
GHWS3600, GHWS3605, GFWS3700 and GFWS3705
For Dryer Models:
GFDS250, GFDS255, GFDS260, GFDS265, GHDS360,
GHDS365, GFDS370 and GFDS375
Instructions en fran_ais : ................ 5
Instrucciones en espaSol: ............... 9
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT- Save these i nstructions forlocal
inspector's use.
• IMPORTANT- Observe oil
g overning
codes and
ordinances.
• Note to Consumer - Keep these instructions for future
reference.
• Completion time - 1 to 2 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
A CAUTION
- Due to the size and weight
of these products, and to reduce the risk of
personal injury or damage to the product, TWO
PEOPLE ARE REQUIRED FOR PROPER INSTALLATION.
° See washer and dryer Owner's IVlanual& Installation
Instructions for additional installation requirements and
guidelines.
KIT CONTENTS
04 Mounting screws -
Dryer
17Drawer divider
04 Mounting bolts-
Washer
TOOLS YOU WILL NEED
17 Phillips-head
screwdriver
08 mm socket wrench
C19/16" socket wrench C] 10" Adjustable
wrench
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay
the washer or dryer down on its side. Continue using
the carton to protect the finished floor in front of the
installation location.
| REMOVE THE LEVELING LEGS
[]
Carefully lay down the appliance to access
the leveling legs on its bottom. The washer
shipping bolts must remain in place until the
washer is returned to an upright position.
Washer - Lay on its back
Dryer - Lay on its side
r_ use an adjustable wrench to remove the
washer or dryer leveling legs.
31-16708 oz-!3 GE
Printed in the United States