Control Panel Indicators - Rimage Professional 3400 Guia Del Usuario

Identify the Parts of the Professional 3400 and 5400N
Parts Information
Control Panel
The control panel is located on the front of the 3400 and 5400N. It includes
the operator panel, the rotate carousel button (button 1), and the printer
tray button (button 2). The control panel allows you to monitor and control
the system.
Important! You must open the front door of the autoloader to access the
control panel.
The table below identifies the name and function of all parts of the control
panel.

Control Panel Indicators

Name Function
Operator The operator panel has a two-line display that informs
panel you of operations or conditions that require operator
intervention. This includes the consumable status. The
5400N displays the name of the embedded PC after
initialization. Refer to the
on page 27 to see other options.
Rotate carousel Press the rotate carousel button to
button (button 1)
• Rotate the carousel and position a bin to load and
unload discs. Each time you press the rotate carousel
button, the carousel rotates to the next bin.
• Enter diagnostic test mode
Printer tray button Press the printer tray button to:
(button 2)
• Open and close the printer tray
• Reset after an error
Printer indicator The printer indicator light illuminates when the printer is
light (on the printer powered on and has completed initialization.
tray button) The printer indicator light flashes when the Everest 400
printer is receiving data from the host.
2001431_C
Operate Gemini Utilities section
For more information visit
Name Function
Rotate carousel The rotate carousel indicator light illuminates when you
indicator light (on rotate the carousel.
the rotate carousel The rotate carousel indicator light flashes when the
button) autoloader is receiving data from the host.
PC Power Button
Only the 5400N has the PC power button. The PC power button powers on
the embedded computer. Refer to the
5400N
section on page 10 for more information.
Disc Dispenser
When a disc is complete, the lift arm places discs on the disc dispenser. The
disc dispenser moves completed discs to the output bin on the left side of
the autoloader. The output bin holds up to 5 discs.
Tip: The carousel will rotate to a bin only after the autoloader has completed
initializing.
rimage.com/support
Operate the Professional 3400 and
9