After Use - Black and Decker BESTA525 Traducción De Las Instrucciones Originales

the way the tool is used, including taking
account of all parts of the operating
cycle such as the times when the tool is
switched off and when it is running idle in
addition to the trigger time.

After use

When not in use, the machine should

be stored in a dry, well ventilated place
out of reach of children.
Children should not have access to

stored machines.
When the machine is stored or

transported in a vehicle it should be
placed in the boot or restrained to
prevent movement following sudden
changes in speed or direction.
Inspection and repairs
Before use, check the machine for

damaged or defective parts. Check
for breakage of parts and any
other conditions that may affect its
operation.
Do not use the machine if any part is

damaged or defective.
Have any damaged or defective parts

repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace

any parts other than those specified in
this manual.
Additional safety instructions for
grass trimmers
Warning! Cutting elements continue to
rotate after the motor is switched off
(Original instructions)
Be familiar with the controls and the

proper use of the machine.
Before use, check the power supply

cord and extension cord for signs of
damage, ageing and wear.
If a cord becomes damaged during
use, disconnect the cord from the
mains supply immediately. DO
NOT TOUCH THE CORD BEFORE
DISCONNECTING THE SUPPLY.
Do not use the machine if the cords

are damaged or worn.
Before using the machine and after

any impact, check for signs of wear or
damage and repair as necessary.
Always ensure that the ventilation slots

are kept clear of debris.
Wear stout shoes or boots to protect

your feet.
Wear long trousers to protect your

legs.
Before using the machine, check that

your cutting path is free from sticks,
stones, wire and any other obstacles.
Only use the machine in the upright

position, with the cutting line near the
ground. Never switch the machine on
in any other position.
Do not overreach and to keep your

balance at all times. Always be sure of
your footing on slopes and walk, never
run.
Do not work on steep slopes. Work

across the face of slopes, not up and
down.
Move slowly when using the machine.

Be aware that freshly cut grass is
.
damp and slippery.
ENGLISH
7