Installation (External Ventilation) - Klarstein BARETT Manual Del Usuario

EN
26

INSTALLATION (EXTERNAL VENTILATION)

Mounting the V flap
If the cooker bonnet does not have a pre-assembled V-flap, install the parts as follows:
1 Install the first half (2) into the housing (6).
2 The pin (3) should be facing upwards.
3 The axle (4) is inserted into the holes (5) on the housing.
4 Repeat all the steps for the second half of the flap.
Installation
If you have an air outlet to the outside, the cooker bonnet can be
connected via an extraction duct (enamel, aluminium, flexible
pipe or non-combustible material with an internal diameter of
150 mm) as shown on the right.