Klarstein BARETT Manual Del Usuario página 35

Stainless steel
The stainless steel must be cleaned regularly (weekly) to ensure a long service life. A
special stainless steel cleaning fluid can be used for this purpose.
Control panel
The control panel can be cleaned with warm soapy water. Make sure the cloth is clean
and thoroughly wrung out before cleaning the control panel. Use a dry, soft cloth to
remove excess moisture after cleaning.
Important: Use neutral cleaning agents and avoid using harsh cleaning chemicals,
strong household cleaners or products containing abrasive cleaners as this will affect
the appearance of the appliance and may remove the printed symbols on the control
panel.
Grease filter
The fabric filters can be cleaned by hand. Soak them in water
together with a grease-dissolving detergent for about 3
minutes and then brush them gently with a soft brush. Do not
apply too much pressure to avoid damaging the filter. Allow
the filter to air dry afterwards, but do not place it directly in
the sun. Filters should always be washed separately from
crockery and kitchen utensils!
Remove the filter as shown in the image on the right and
then reinsert the filter in the reverse order.
EN
35