Sinbo SK 7334 Manual De Instrucciones página 10

NAMES OF MAIN PARTS
1
2
1. Lid
2. Switch
3. Stainless Steel Body
4
3
4. Handle
5. Indicator Light
6. Power Base
5
6
OPERATION
For the first time to use or no use for long time, we recommend that you fill to the
maximum level mark with fresh tap water, boil and empty the kettle then wash it with
water, repeat the operations above at least 2 times.
1. Pull out the power cord from the compartment of the base unit, connect the plug into
a power outlet.
2. Open the lid then fill the water into the kettle.
3. Never allow the water above the maximum level or lower than the minimum level.
4. Close the lid and lock it fully. Please exactly the kettle back on the base unit.
5. Switch the kettle on by pressing the switch at "I" position, the light will illuminate to
indicate the kettle is heating.
6. The kettle will automatically switch off at "O" position once the water has boiled and
the neon light does off.
NOTE: If you need heat the water again, should switch it on after 30-60 seconds.
7. Lift the kettle from the base by handle and pour out the water into container
NOTE: The switch just can work when the kettle body place exactly on the base unit.
TECHNIQUE PARAMETER
* Capacity: 1.8L
* AC230V, 50Hz, 1800W
* 360 cordless jug kettle
* Automatically turns off when water boils
* With boil dry protection
* On/off switch
* With SUS304 heating element
* With VDE plug and cord
* With Chinese controller
* S/S body
- 9 -