BaByliss PRO VOLARE X2 maxlife pro Manual Del Usuario página 10

Red: the unit is charging.
Blue: the unit is fully charged.
Slow Flashing Red: early warning indicates the unit will soon need to be charged.
Rapid Flashing Red: indicates only 10 to 15 minutes more run time.
AC OPERATION
You can use your clipper even when the battery capacity is low.
1. Make sure the power switch is off before connecting the adapter.
2. Connect the AC adapter in the same way as for charging. Plug adapter into outlet.
The red charging light will come on.
3. Move the power switch to the ON position. The red charging light will stay on for a
second and then the unit will start.
4. If the clipper does not operate, charge the clipper for approximately 1 minute.
Slide the taper control up or down to adjust the moving blade to the desired height.
The blade is adjustable in four (4) stages from 0.8 mm to 2.0 mm, in 0.4 mm steps
without attachments. The actual cut length may be longer than the set length.
Using the Comb Attachments
1. Select the desired comb attachment.
Trimming height is indicated on the outside and sides of the attachments.
2. Set the taper control to 0.8 and then mount the attachment to the clipper.
3. To attach the comb, do not press on the tab. You must press over the number as
shown. The tab is only for comb removal.
Press here to attach.
10
Push up
here
to remove.