Switch Leds - Allied Telesyn AT-8316F/MT Guía De Instalación Rápida

You are now ready to use the Omega management software to configure the
switch. For instructions, refer to the AT-S25 Management Software User's
Guide. This guide is available on the Allied Telesyn web site at
www.alliedtelesyn.com/techhome.htm.

Switch LEDs

Table 2 and Table 3 describe the functions of the LEDs on the Ethernet
switch.
LED
Fault
Master
RPS (Redundant
Power Supply)
Power
Table 2 Power and Fault LEDs
State Description
Solid Red The switch or management software is malfunctioning.
Flashing Red The switch is booting, running diagnostic tests, writing
images to Flash, or transferring files using XMODEM or
TFTP.
OFF Normal operation.
Solid Amber The switch is functioning as the master switch of the
stack.
Flashing Amber The switch is building a topology of the Ethernet stack.
OFF The switch is installed as a standalone unit or is
functioning as a slave switch in a stack.
Solid Green The RPS is connected to the switch. To verify that the
RPS is operating correctly, refer to the instructions in the
RPS Quick Install Guide.
Solid Green The switch is receiving power, voltage is within the
acceptable range, and the power supply is working.
AT-8316F and AT-8324 Quick Install Guide
11