Fanaway Corbelle Instrucciones De Instalación página 9

Fanaway Corbelle Installation Instructions
WARNING: FOR YOUR SAFETY ALL ELECTRICAL CONNECTIONS MUST BE UNDERTAKEN BY A
LICENSED ELECTRICIAN.
NOTE: AN ADDITIONAL ALL POLE DISCONNECTION SWITCH MUST BE INCLUDED IN THE FIXED
WIRING.
See Fig. 8 for instructions below to wire up the fan.
• Connect "LIVE" supply wire to the "L" of terminal block on the mounting bracket.
• Connect "NEUTRAL" supply wire to the "N" of terminal block on the mounting bracket.
• Connect "EARTH" wire to the "
• Hang the fan (Refer to "hanging the fan" Fig. 5, page 6).
• Connect the quick connector from bracket (label 1) the receiver supply input quick connector (label 2);
• Connect the receiver output quick connector (label 3) to the quick connector of the fan (label 4).
• Carefully insert the Remote Receiver above the hanger ball in the remainder spacing in the mounting
bracket. Take care not to damage or loosen any of the wiring. (label 5 & Fig. 9).
4
8 | P a g e
ELECTRICAL WIRING DIAGRAM THE FAN
" of terminal block on the mouthing bracket.
3
5
Place remote
receiver here
1
2
Fig. 8