Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 7
Figure 8
Metal
Insert
Figure 10
Wire
Loop
Figure 11
Metal
Insert
PAGE 3 OF 12
PANEL ASSEMBLY
INSTALLATION OF SELF-LEVELING FEET
Top Cap
1. Remove plastic top caps from all four posts. (See Figure 6)
Figure 6
2. Remove floor protectors and leveling bolts from metal inserts of
self-leveling feet located in post boxes. (See Figure 7)
3. Install metal inserts into holes where plastic top caps were. Make sure
insert is fully set into top of post. Tap into place with rubber mallet.
(See Figure 8)
ATTACH SIDE PANELS
1. Assemble side panels with loops on top facing inward. Tilt panel so it
locks around posts on both ends, then slide down so loops are on top
of the metal insert that was installed at the top of the post.
(See Figure 9)
2. Repeat with second side panel.
Figure 9
ATTACH BACK PANELS
1. Assemble back left panel first. Place wires facing downward into
loops on side panel. (See Figure 10)
2. Repeat for the back right panel.
3. After all the loops are aligned on top of the metal inserts on the top of
the posts, screw in the bolt on all four posts and tighten using wrench.
(See Figure 11)
NOTE: Do not screw in bolts until all panels are installed.
0321 IH-2083
Publicidad
