HJM 825 Instrucciones De Uso página 14

Radiador Aceite Mini
TO ASSEMBLE
Do not operate the heater without fitting the feet to the bottom of the heater, otherwise it may
result in a fire hazard.
1. Remove the heater from the packaging, turn upside down and rest on the polystyrene.
Check that neither the heater nor the power cable has been damaged in any way during
transportation.
2. Do not operate the appliance if damaged. Remove the feet from packing. Turn the heater
upside-down on a rug or a soft surface in order to prevent damaging the paint finish.
3. Put the feet into the correct position as shown in figures 1 and 2
4. Turn the heater to its upright position for operation.
5. ELECTRICAL CONECTION
• Before plugging the radiator into the mains, check that the voltage of your mains electricity
supply corresponds to the value V indicated on the appliance and that the socket and
power line are appropriately dimensioned.
CAUTION: Only operate the heater in normal upright position with Feet attached to
the bottom of the heater, any other position could create a hazardous situation
TO OPERATE
- Place the heater in an upright position on a flat, steady, stable, heat-resistant surface. Make
sure there is nothing flammable or heat sensitive within 1 meter (40 inches). Operating the
heater in any other position could cause a hazard.
- Insert the plug into a suitable wall outlet on an A.C. power supply having the same voltage
as that show on it's rating label after turning the thermostat knob counter-clockwise to the
minimum position
- Turn the thermostat knob clockwise to maximum position. When the temperature rises to
with a comfortable level, slowly turn thermostat counter-clockwise until the power indicator
light just goes out. To adjust the room temperature turn the thermostat clockwise to raise
the temperature, or counter-clockwise to lower it. Your unit will be automatically set an on-
and-off cycle to maintain the current room temperature according to thermostat setting.
(Note: It normally requires approx. 15 minutes to reach the operating temperature.)
- To turn the appliance off, turn the thermostat to "O" and remove plug from the wall socket.
- Unplug the heater from the electrical outlet when it is left unattended or is not in use.
13/5/11 10:08 Página 14
- 14 -
E
N
G
L
I
S
H