Sauder 418269 Manual De Instrucciones página 13

Step 9
Carefully stand your unit upright.
å
Fasten the HUTCH UPRIGHTS (C and M) to the TOP (E).
å
Tighten four TWIST-LOCK® FASTENERS.
Fill the holes in the edges of the HUTCH UPRIGHTS (C
å
and M) 1/4 to 1/2 full with GLUE (54M). Then, insert eight
WOOD DOWELS (15F) into the holes. Wipe away the
excess GLUE.
Place drops of GLUE (54M) onto the WOOD
å
DOWELS (15F) in the HUTCH UPRIGHTS (C and M).
Press the HUTCH TOP (F) onto the WOOD DOWELS in
å
the HUTCH UPRIGHTS. Wipe away the excess GLUE.
(8 used)
15F
Surface with
TWIST-LOCK®
FASTENER
www.sauder.com/services
F
M
M
E
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Unfi nished edge
Surface without
C
TWIST-LOCK®
FASTENER
C
418269
® FASTENER
Dowel end
Caution
!
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely diffi cult.
Fill the holes 1/4 to 1/2 full with GLUE.
54M
Page 13