Bosch LR 1 Professional Manual Del Usuario página 24

OBJ_BUCH-780-002.book Page 24 Tuesday, July 22, 2008 9:13 AM
24 | English
Attaching with the Holder (see figure A)
With the holder 17, the measuring tool can be fastened to a con-
struction laser measuring rod 15 (accessory) as well as to other
auxiliary tools with a width of up to 65 mm.
Screw the holder 17 to the retainer opening 12 on the rear side of
the measuring tool with fastening screw 16.
Loosen the locking screw 13, slide the holder onto the construc-
tion laser measuring rod 15, for example, and retighten the locking
screw 13.
The holder 17 can be horizontally aligned with help of the spirit
level 18.
The upper edge 14 of the holder is located at the same height as
the centre mark 5 and can be used for marking of the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the
measuring tool can be attached to steel parts via the face side
using the magnet plate 4.
1 609 929 R59 | (22.7.08) Bosch Power Tools