OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the two screws from the back of the
worktop, lift the back of the worktop and pull
it toward the front of the appliance to remove
it. Remove the worktop hinge hole cover from
the left side of the worktop and move it to the
hinge hole on the right side of the worktop.
See fi gure 1.
2. Remove the screw from the door spindle cover
and remove the upper right hinge and door
from the chassis. Remove the door spindle from
the upper right hinge. See fi gure 2.
3. Remove the lower hinge hole cover from the
bottom left side of the door and move it to the
bottom right side of the door. See fi gure 3.
4. Remove the adjustable foot and the two screws
holding the bottom hinge. Move the bottom
hinge to the left side of the chassis and install
with the screws. Install the adjustable foot on the
left side of the appliance and move the solid foot
to the right side of the appliance. See fi gure 4.
5. The upper left hinge is in the accessory bag
inside the appliance. Install the door spindle
on the upper left hinge. Install the upper left
hinge and door onto the chassis. Install the door
spindle cover with a screw. Reinstall the worktop
by laying it on top of the appliance and pushing
it toward the back until it clicks into place and
then reinstall the two screws at the back. See
fi gure 5.
Note: When reinstalling the door, ensure that the
top of the door is level with the top of the chassis
and that the rubber gasket makes a good seal with
the chassis all the way around.
A. Worktop Hinge Hole Cover
B. Worktop
C. Door Hinge Hole Cover
D. Door Spindle Cover
E. Door Spindle
1
2
3
4
5
5