Publicidad
Step 12
å
Carefully stand your unit upright.
å
Open the FURNITURE TIPPING RESTRAINT KIT (98) and fasten the SAFETY STRAP to the TOP (F) shown. Use the
provided short screw.
å
Place your unit in its final location against a wall. Locate the center of a stud in your wall near your unit and mark it
with a pencil. Next, drill a 1/8" hole on the mark and into the stud in your wall.
å
Fasten the unit to the wall. Use the long screw through the other end of the strap and into the 1/8" hole.
å
Insert the SHELF PINS (8) into the hole locations of your choice in the RIGHT END (B) and UPRIGHT (C).
Drill 1/8" hole into
a stud in your wall.
98
Electric drill with 1/8" bit
Page 16
Use the short screw through
the hole in the strap and into
the top surface of the
TOP (F).
98
www.sauder.com/service
F
8
B
C
8
(12 used)
426930
Publicidad
