Sauder Shoal Creek 422191 Folleto De Instrucciones página 10

Step 6
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the enlarged diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the RIGHT END (A) and RIGHT UPRIGHT (E). Use four GOLD 5/16" FLAT
å
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this
hole.
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
å
35MC
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Page 10
E
35MA
A
422191
Open end
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services