Sauder Shoal Creek 422191 Folleto De Instrucciones página 8

Step 4
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the LEFT END (B) until the shoulders of the SCREWS rest
on the surfaces of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the LEFT END MOLDING (L) onto the LEFT END (B).
å
Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the END.
NOTE: The MOLDINGS should be even on both edges of
å
the END.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
Page 8
B
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
422191
Just think. The sooner
you do this, the sooner
you do something else.
32S
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
www.sauder.com/services
L