Using The Controls - Whirlpool WRFA32SMHZ Manual De Instrucciones Para El Usuario

Using the Controls

The control center is located at the top front of the refrigerator
compartment.
Temperature Controls
For your convenience, your temperature controls are preset at
the factory. When you first install your refrigerator, make sure the
controls are still set to the recommended set points as shown.
Recommended Settings
IMPORTANT:
The recommended settings should be correct for normal
■
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is firm.
When the power is on, the temperature display shows the set
■
point temperature of the compartment.
Wait 24 hours for your refrigerator to cool completely before
■
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
If the temperature is too warm or too cold in the refrigerator
■
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
To Turn Your Refrigerator Off/On:
Press the freezer (+) touch pad repeatedly until "OFF"
■
appears in the freezer display. Allow a few seconds for the
refrigerator to shut off. Neither compartment will cool.
Press either the refrigerator or freezer (-) touch pad to turn on
■
the refrigerator.
Adjusting Controls
The REFRIGERATOR control adjusts the refrigerator
compartment temperature. The FREEZER control adjusts the
freezer compartment temperature.
If you need to adjust the temperature in either the refrigerator
or freezer compartment, use the settings listed in the chart as a
guide.
To Adjust Set Point Temperatures:
The first touch of the (+) or (-) touch pad displays the current
temperature set point.
Press the (+) or (-) touch pads until the desired temperature
■
set point is displayed.
NOTE: Except when first turning on the refrigerator, do not
adjust either temperature control more than one setting at a time.
Wait 24 hours between adjustments for the temperature to
stabilize.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/too little ice
REFRIGERATOR too cold
FREEZER too cold
Additional Control Center Features
Max Ice
The Max Ice feature assists with temporary periods of heavy ice
use by increasing ice production.
Press the Max Ice feature touch pad to set the freezer to the
■
lowest temperature setting. Press the Max Ice feature touch
pad again to return to the normal freezer set point.
NOTE: The Max Ice feature will automatically shut off in
approximately 24 hours.
Humidity Control
The Humidity Control feature turns on a heater to help reduce
moisture on the door hinge seal. Use in humid environments
or when you notice moisture on the door hinge seal. The
refrigerator uses more energy when Humidity Control is on.
Press Humidity Control when the environment is warm and
■
more humid, or if you notice moisture on the door hinge seal.
The indicator light will be lit when humidity control is ON.
Press Humidity Control to save energy when the environment
■
is less humid.
Temp Alarm
The Temp Alarm feature provides temperature information in the
event of a power outage.
Power outage: During a power outage, if the temperatures
in the refrigerator and freezer compartments exceed normal
operating temperatures, the highest temperature reached will be
displayed.
ADJUSTMENT:
REFRIGERATOR Control
1° lower
Adjust FREEZER Control
1° lower
Adjust REFRIGERATOR
Control 1° higher
Adjust FREEZER Control
1° higher
13