Special Messages - Mellerware Cheffy! Manual Del Usuario

The appliance needs a 6-15L pot
–
or container.
Plug the appliance into the mains.
–
The indicator light will illuminate red
–
and the appliance will enter into
standby mode.
–
setting mode. A beep will be heard.
Select the temperature using the
–
+/- buttons. Once the temperature
is selected, press the settings
button to select the time.
Select the hours using the +/-
–
buttons. Press the settings button
again to select the minutes.
–
the settings. The appliance will
enter heating mode. The indicator
light will illuminate blue.
The temperature will appear
–
on the screen.
To modify the settings, press the
–
repeat the previous instructions.
When the appliance reaches the
–
selected temperature, 2 beeps will
The timer will start to count down.
When the time is up, 3 "beeps" will
–
be heard and "END" will appear on
the display. The device will enter
standby mode automatically.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE
Stop the appliance by pressing the
–
Unplug the appliance from
–
the mains.
Clean the appliance.
–
SAFETY THERMAL PROTECTOR
The appliance has a safety device,
–
which protects the appliance
from overheating.
When the appliance switches itself
–
other than the thermostat control,
check to ensure that there are no
obstacles that impede correct air
entry or expulsion.
–
does not switch itself on again,
disconnect it from the mains
supply, and wait for approximately
15 minutes before reconnecting.
If the machine does not start
again seek authorised technical
assistance.

SPECIAL MESSAGES

The following message EE1
–
may appear on the screen,
accompanied by 3 "beeps", which
could mean that:
- The water level is below the
minimum level.
- The appliance has been taken
out of the water while it was
working.
- The water has evaporated.
- The appliance is being used
without water.
Cleaning
Disconnect the appliance from the
–
mains and allow it to cool before
undertaking any cleaning task.
EN ES