Battery Installation - Uline H-1585 Guia De Inicio Rapido

1. Open dispenser by pushing
Figure 9
2. Remove two screws securing
Figure 10
3. Use 3 high-quality C-cell alkaline
Figure 11
1. Open dispenser by pushing
Figure 14
2. Check that the color of refill
Figure 15
3. Insert refill at slight angle into
Figure 16
PAGE 2 OF 9

BATTERY INSTALLATION

release on bottom of dispenser.
(See Figure 9)
battery box cover using Phillips
screwdriver. (See Figure 10)
batteries (not included).
(See Figure 11)
NOTE: Do not mix old and
new batteries.
release on bottom of dispenser.
(See Figure 14)
collar key matches color key
located immediately below
status light. (See Figure 15)
dispenser so nozzle is inside lock
release. (See Figure 16)
Figure 12
Figure 13
LOADING REFILL
Figure 17
Figure 18
4. Replace battery box cover,
being careful not to over-tighten
screws. (See Figure 12)
5. Close dispenser cover. Status
light will blink green after closing,
indicating that batteries are
correctly installed and dispenser
is ready to accept refills.
(See Figure 13)
4. Fully insert refill down into lock
release until refill clicks into
place. Close dispenser. Prime
refill pump by placing hands
below dispenser until product is
dispensed. (See Figure 17)
(See Dispenser Use)
5. To remove refill, press lock
release and lift refill up and out
of dispenser. (See Figure 18)
0821 IH-1585