Technical Data - Q-Connect STANDARD COMB BINDER 8 Manual De Instrucciones

1 Carrying Slot
2 Punching and Binding Handle
3 Punching Channel
4 Comb Opening Lock
5 Binding Mechanism
6 Edge guide
7 Waste Tray
EDgE AlIgNMENT (A)
The adjustable Edge Guide allows pages of various
sizes to be accurately aligned for the best punching
results. Move the edge guide left or right and stop
at the required position. Test punching the scrap
sheet and re-adjust if necessary.
PuNChINg
With the Punching Handle in the vertical position,
align sheets or covers and insert the edge to be
bound into the Punching Channel and ensure they
are aligned to the Edge Guide.
ing Handle all the way down.
The STANDARD COMB BINDER 8 can punch max.
8 sheets of 80 gsm paper at once. Punch max. 1
plastic cover at a time.
Move the punching Handle upwards again and
remove the punched document.
BINDINg
Place a plastic comb with the side to be opened
upwards onto the Binding Mechanism. Pull down
the Punching Handle so far that the comb is
(D)
opened enough.
Press the Comb Opening Lock to secure the
opened comb.
Position the punched sheets vertically in the open
(E)
comb. Locate the punched holes over the
open comb fingers and rotate the sheets forward
onto the comb.
When all the sheets are loaded onto the plastic
comb, release the Comb Opening Lock. Pull up the
Binding Handle to its original
position to close the plastic comb completely. You
can now remove the bound booklet and enjoy
your finished work.
(B)
Pull the Punch-
(C)
3
EMPTyINg ThE wASTE TRAy
Take out the waste tray from the back side of
the machine. For best results, empty the tray
regularly.
STORAgE
Close all lids and move handles to rest position.
gENERAl SAFEguARDS
Place the comb binder on a secure and stable
work table to
prevent it from falling and causing personal
injury and damage to the machine.
Use the machine only for its intended purpose.
Always test the machine with some scrap pa-
per before punching the final document.
When punching plastic covers, we recommend
to punch the cover with a sheet of paper on
both sides.
Empty the waste tray regularly.
Lift the machine from the bottom or the carry-
ing slot, not from the lids or handles.
Unauthorised maintenance is not allowed.

TEChNICAl DATA

Punching capacity: 8 sheets (80gsm).
Number of punches: 21 rectangular holes
Binding capacity: 140 sheets.
Maximum binding comb: 20 mm.
t