Troubleshooting - Team kalorik TKG VC 1022 Manual De Instrucciones

Fax +32 2 359 95 50

container until it snaps into place. Your cyclone vacuum cleaner is now ready for use
again.
Motor protection valve
The unit has the protection valve, when the dust cup is full of dust , HEPA filter is blocked or the
air path is blocked, the protection valve will turn on automatically avoiding motor over-heat in
order to prolong the life of motor.
Cleaning the other parts of the vaccum cleaner
The casing, dust collecting chamber and filter chambers of the vacuum cleaner can be wiped
with a damp cloth if required. No liquid must enter the vacuum cleaner in the process. Never
use strong cleaning substance(scouring liquids, thinners), since these will corrode the plastic
surface. Only place the plug back in the mains socket when you have made sure that all the
parts are thoroughly dry.
Hair and fluff may gather on the running wheels and on the floor nozzle of the vacuum cleaner
in time.
You should remove these to ensure that handling of the vacuum cleaner is always easy.
Note! Lubricating or oiling of the roller bearing is not recommended, because this will cause dirt
and fluff to stick even better.
PRAKTICKÉ TIPY
•
Keď vysávate schody, odporúčame prístroj nechať vo vertikálnej polohe.
•
Podlahová dýza je vybavená háčikom, na ktorý môžete pripevniť hubicu buď keď
potrebujete odložiť nábytok počas vysávania alebo po ukončení a uschovaní prístroja.
•
Vysávač si ináč nevyžaduje žiadnu inú údržbu ako výmenu vrecka a čistenie filtrov.
TROUBLE-SHOOTING
Faults can occur on all electrical equipment. This must not necessarily be due to a defect in
the device itself. So check first with table if the fault can be dealt with.
PROBLEM
Weak suction
Device does not work.
Whistling sound during
The first hours of
operation
The device cover does
not close properly.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
POSSIBLE CAUSES
The secondary valve is
open.
An object is blocking the
suction pipe
Filters are not fitted
properly or are blocked
Device is not properly
plugged into the mains
This is not a fault
Dust container is not set
properly
59
Assembly page 59/67
special instruction from
SOLUTIONS / TIPS
Close the secondary valve
Check the suction tube, the
handle area, suction pipe and
the nozzle in use for blockages.
Fit a new filter
Check that the mains plug has
been inserted properly. Also
check whether the power
socket is in order. Check the
fuses! Automatic fuses in the
fuse box
The noise will die away by itself
after a time
Check the dust container fit.
TKG VC 1022 - 170214
Team