Assembling The Vacuum Cleaner - Team kalorik TKG VC 1022 Manual De Instrucciones

Fax +32 2 359 95 50

If your appliance no longer vacuums correctly or if the dust

container is full, clean the filter and empty the dust container in
order to prevent the appliance from overheating.
Use extra care when cleaning on stairs.

Do not handle plug or vacuum cleaner with wet hands.

Keep hair, loose clothing, fingers and all parts of body away from

openings and moving parts.
(*) Kompetentní kvalifikovaný elektrikář: poprodejní oddělení výrobce nebo dovozce nebo osoba, která
je kvalifikovaná, schválena a kompetentní k provádění takových oprav s cílem předcházení jakýmkoli
nebezpečím. V každém případě byste měli vrátit zařízení takovému elektrikáři.
Using the appliance when not all the filters are installed properly and in good shape might
damage the appliance. No guarantee claims will be accepted for damages due to that
reason.

ASSEMBLING THE VACUUM CLEANER

•
Always remove the plug from the power socket before fitting or removing accessories!
•
Insert the hose connector into the hose connection inlet until it locks. To remove the hose,
press the sides of the hose connector and pull at the hose (A, s.5).
•
Fit the tube to the handle of the flexible hose.
•
Connect the plastic tube with another plastic tube.
•
Fit the tube to the floor brush (C).
•
Removing tube and accessories: to remove the accessories, pull firmly apart.
•
The floor brush is ideal for the daily cleaning of carpets and hard floors.
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
•
The appliance is delivered with the following accessories:


OPERATION
•
Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark. Switch on the appliance by pressing the ON/OFF switch with your
foot.
•
It is advisable to set the electronic power regulator to the minimum position before
switching on the appliance. By turning the regulator button, the suction power can be
adjusted. You can also adjust the suction power by using the wind-force adjuster on the
handle of the flexible hose (B). Use a low suction power for furniture and other delicate
surfaces and use high suction power for fitted carpet and other floors.
AFTER USE
•
Stop the vacuum cleaner by pressing the ON/OFF switch.
•
Unplug the appliance from the power supply.
•
Simply press the cable rewind button to activate the cable rewind
mechanism.
•
The carrying handle can be used to move the appliance.
•
After use we advise you to empty the dust collector to avoid smells and mildew that could
be caused by damp dust particles that may have been vacuumed, and also to
guarantee an optimal efficiency during the next use. To do so, see below.
Copies of the I/B. Please reproduce them without any
changes except
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
a crevice tool: for radiators, crevices, corners, baseboards and between
cushions (E).
an upholstery brush: for curtains, cushions, edges, doors, mattresses etc. (D).
Assembly page 63/67
under special instruction
63
from Team
TKG VC 1022 - 170214