safety
●
Watch out for steam, never lift the
tank lid during the brewing cycle.
●
CM370 series only: never touch
the hotplate.
●
Always lift the lid using the lid
opening lip.
Keep children away from the
●
machine. And never let the cord
hang down where a child could
grab it. Push excess cord inside the
back of the machine.
Never use a damaged machine. Get
●
it checked or repaired: see 'service
and customer care'.
Never put the machine in water or
●
let the cord or plug get wet - you
could get an electric shock.
Unplug:
●
before filling with water
● ●
before cleaning
● ●
after use.
● ●
Never leave the machine on
●
unattended.
Don't let the cord touch hot parts.
●
Always make sure there is water in
●
the tank before switching on.
This coffee maker is only suitable for
●
use with the type of carafe supplied.
●
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
●
Children should be supervised to
ensure that they do not play with the
appliance.
●
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Remove all packaging.
2 Wash the parts: see 'care and
cleaning'.
3 Push excess cord inside the back of
the machine.
4 Run two lots of water through the
machine (without coffee) to clean it
out. Fill the tank to the top cup mark
when you do this. See 'to make
coffee'.
key
water filter
water filter holder
removable water tank
lid
compartment for excess cord
on/off switch with indicator light
hotplate (model CM370 series only)
anti drip activating device
glass carafe and lid
(model CM370 series only)
thermal carafe and lid
(model CM380 series only)
measuring spoon
filter holder
permanent coffee filter (or use a
paper filter instead)
lid opening lip
aroma control
to make coffee
1 Lift the lid.
2 Lift out the water tank from the
coffee maker.
3 Separate the water filter holder by
pulling the unit apart and place the
water filter inside. Fit the unit back
together.
2