Connections (Front); Using The Remote Control; Installing Batteries - Teac UD-701N Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connections (front)

Connecting headphones
CAUTION
V
While wearing headphones, do not connect or disconnect them or
turn the unit on or off.
Doing so could result in a sudden loud noise that could harm your
hearing.
Before putting headphones on, always set the volume to
minimum (display should show "0" when set to "STEP (0-100)"
or "−∞ dB" when set to "dB") (page 18).
UNBALANCED
Connect headphones with a standard 6.3mm (1/4") stereo plug here.
BALANCED
Connect headphones with a 4-pin XLR plug here.
12
PIN assignments of
this unit
4
1
3
2
1: L+, 2: L−
3: R+, 4: R−

Using the remote control

Precautions for use
V
Misuse of batteries could cause them to rupture
or leak, which might result in fire, injury or the
staining of nearby materials. Please carefully read
and observe the precautions on page 3.
o When using the remote control, point it toward the remote con-
trol signal receiver on the main unit from a distance of 5 m (16 ft)
or less. Do not place obstructions between the main unit and the
remote control.
o The remote control might not work if the remote control signal
receiver on the unit is exposed to direct sunlight or bright light. If
this occurs, try moving the unit.
o Beware that use of this remote control could cause the unin-
tentional operation of other devices that can be controlled by
infrared rays.

Installing batteries

Remove the cover from the back of the remote control and insert
two AAA batteries with their ¥/^ oriented as shown in the case.
Replace the cover.
When to replace batteries
If the distance required between the remote and the main unit
decreases or if the unit stops responding to the remote buttons,
replace both batteries with new ones.
Dispose of the used batteries according to the instructions on them
or requirements set by your local municipality.

Publicidad

Tabla de contenido
loading

Tabla de contenido