Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Display

When on
Z
After messages like the above appear, the input source will be shown
on the display.
Playback source screen
The playback source screen will appear after turning the unit on as
well as after about seven seconds pass without operation when a
setting screen is open.
The input signal format or volume is shown to the right of the play-
back source. Press the DISPLAY button on the remote control to
change what is shown.
Display examples
Playback source information screen
Stopped
Playback source
USB
Playing back
USB
Press the DISPLAY button on the remote control.
Volume display
USB
16
CHECK
Shown when the connection is
being checked
Input signal format
PCM
44.1k
Sampling frequency
−45.5
dB
Volume
Playback source name
This shows the name of the selected source.
The names on the display correspond to the selected connectors as
follows.
The names in parentheses appear when switching.
USB (USB)
USB port (USB Type B on back)
COAX1 (COAXIAL 1)
RCA COAXIAL digital audio input connector 1
COAX2 (COAXIAL 2)
RCA COAXIAL digital audio input connector 2
OPT1 (OPTICAL 1)
OPTICAL digital audio input connector 1
OPT2 (OPTICAL 2)
OPTICAL digital audio input connector 2
NET (NETWORK)
ETHERNET port
Bluetooth (Bluetooth)
Bluetooth device
LINE RCA (LINE RCA)
RCA analog audio input connectors
LINE XLR (LINE XLR)
XLR analog audio input connectors
Input signal status
This shows the input source signal status.
NOTE
Nothing will be shown when set to LINE RCA or LINE XLR.
CHECK
The connection is being checked.
PCM 32kHz
PCM 44.1kHz
PCM 48kHz
PCM 88.2kHz
PCM 96kHz
PCM 128kHz
PCM 176.4kHz
PCM 192kHz
PCM 256kHz
PCM 352.8kHz
PCM 384kHz
DSD 2.8MHz
DSD 5.6MHz
DSD 11.2MHz
DSD 22.5MHz
These show the input signal type and sampling frequency.

Publicidad

Tabla de contenido
loading

Tabla de contenido