Beamz 150.446 Manual De Instrucciones página 4

CONNECTIONS
First connect all signal leads prior to connecting the mains lead to a mains outlet!!
Connection if several moving heads must operate together (Master/Slave):
I
DMX
IN
Connect the moving heads via 3-pin XLR leads as indicated in the illustration above if you want to
operate them in Master-Slave mode.
The wiring of an XLR connector is indicated below:
1. Earth
2. Signal –
3. Signal +
DMX512 PROTOCOLE
5 CHANNEL MODE
Channel 1: Pan, The moving head can rotate horizontally up to 540° and stop in any position.
Channel 2: Tilt, The moving head can rotate vertically up to 270° and stop in any position.
Channel 3: Shutter and stroboscope
0-9 Shutter closed
10-134 Shutter open 0-100%
135-239 Stroboscope (slow to fast)
240-255 Shutter open
OUT
An end-of-line resistor of 120Ω/1W must be connected on the last
unit of the chain (DMX OUT between pin 2 & 3).
I OUT
Channel 4: Colours
0-7
8-21
22-35
36-49
50-63
64-77
78-91
92-105
106-119
120-133
134-147
148-161
162-189
190-203
204-217
218-231
232-255
I OUT
DMX
OUT
Closed
Open / White
Red
Green
UV
Light blue
Pink
Yellow
Magenta
Pink II
Light green
Light Magenta
Dark blue
Light pink
White II
White III
Rainbow effect