Beamz 150.446 Manual De Instrucciones página 6

Channel 13: Gobos
0-12
Open
13-25
Gobo 1
26-38
Gobo 2
39-51
Gobo 3
52-64
Gobo 4
65-77
Gobo 5
78-90
Gobo 6
91-103
Gobo 7
The address of the first unit is 1(001). For the second unit it is 1+13= 14(014) and for the third 14+13=
27(027) etc.
Make sure that the channels don't overlap otherwise the units will not work properly. NB: If two units
have the same address, the both operate in the same way.
Once all units have got an address, you can start operation via the controller. The unit will recognize
immediately if it receives data or not. If it doesn't receive any data, the LED will not flash. If the system
doesn't work, check the XLR connectors and the leads. It is also possible that the controller is faulty.
Connect an end-of-line resistor of 120Ω/1W to the last unit in order to ensure proper data transmission.
MODE 1:
Standard mode. DMX512 signal: search the desired address via the UP/DOWN buttons.
DMX mode: Channel 1 - Channel 512
MODE 2:
and search for the desired function via the UP/DOWN buttons.
the master sound control mode.
Press ENTER to save the function. Then
changes into
SETTINGS
You can allocate the DMX addresses to the moving head via the
control panel on top of the unit. Please keep in mind that the moving
head has 13 channels when it is connected to a controller. If you use
several units (Master-slave) you need to be aware of the following:
: Press the ESC button until one the previous messages displays
is the "easy" controller mode and
changes into
and .
104-116
Gobo 8
117-127
Gobo 9
128-191 Positive rainbow
effect with increasing
speed
192-255 Negative rainbow
effect with increasing
speed
is the master auto mode,
,
is the slave mode.
changes into
is
,