Publicidad
Idiomas disponibles
Idiomas disponibles
Whenever the appliance fails to work, check for a solution from the following list before calling for Technical
Assistance Centre.
Malfunction:
The dishwasher does not start.
No water enters the
dishwasher.
No water drains out from the
dishwasher.
The dishw ash er m akes
ex ce s sive n o ise .
The dishes and glasses are
cov e red in a w h it e f ilm o r
lim es c ale d epo sit s.
The dishes and glasses are
strea k ed o r ha v e a b lu ish
tinge.
The crockery has not been
dried properly.
The dishes are not clean.
Shut off tap alarm.
(several short beeps are emitted)
nd
rd
(the 2
and 3
WASH CYCLE
indicator lights flash, beginning
from the right).
Blocked filter alarm
nd
(the 2
and 4th WASH CYCLE
indicator lights flash beginning
from the right).
Water loading solenoid valve
malfunction alarm
(the 3
WASH CYCLE indicator
rd
lights flash beginning from the
right).
Possible causes / Solutions:
• The plug has not been inserted into the electrical socket
properly, or there is no power in the house.
• The dishwasher door has not been shut properly.
• A delayed start has been programmed (see Start-up and use).
• There is no wate r in the mains supply.
• The water inlet hose is bent (see Installation).
• The dishwasher cycle has not yet finished.
• The water outlet hose is bent (see Installation).
• The drain duct is blocked.
• The filter is clogged up with food residues.
• The dishes are ra ttling against each other or against the
sprayer arms.
• The level of the refined salt is low or the dosage setting is not
suited to the hardness of the water (see Rinse aid an d salt).
• The lid on the salt dispenser is not closed properly.
• The rinse aid has been used up or the dosage is too low.
• The crockery is m ade from non-stick material.
• The rinse aid dosage is too high.
• The rinse aid has been used up or the dosage is too low (see
Rinse aid and salt).
• The rinse aid dispenser setting is not high enough.
• A wash cycle without a drying programme has been selected.
• The racks are overloaded (see Loading the racks).
• The crockery has not been arranged well.
• The sprayer arms cannot move freely.
• The wash cycle is to o gentle (see Wash cycles).
• The detergent has not been measured out correctly or it is not
suited to the type of wash cycle (see Start-up and use ).
• The filter is dirty or blocked (see Care and maintenance).
• The refined salt level is low (see Rinse aid an d salt).
• Turn on the tap and the appliance will start after a few
minutes.
• The appliance lock has been activated because no action was
taken when the b eeps sounded. Switch off the machine using
the ON/OFF button, turn on the tap and switch the machine
back on after 20 seconds by pressing the same button. Re-
programme the machine and
restart the wash cycle.
• Switch off the machine by pressing the ON/OFF button and
clean the filters (see Maintenance), then switch the
dishwasher back on by pressing the same button. Re-
programme the machine and restart the wash cycle.
• Switch off the ap pliance by pressing the ON/OFF button and
switch it back on after a minute. If the alarm continues, turn
off the water tap to reduce the risk of flooding, remove the
plug from the electrical socket and call Assistance.
Publicidad
