Greenlee 555C Manual De Instrucciones página 10

Setup (cont'd)
3.06"
(77.7 mm)
Leveling Screw
Hex Head Screws
Trap Plate
IMC Single-Shoe Roller Support Unit Installed
Greenlee Tools, Inc.
3. Mark the conduit. See the decals on the bender or
4. Place the bender in either the vertical or horizontal
Install pin.
10
555C Electric Bender Classic
Note: The IMC single-shoe roller support has a
trap plate that may require adjustment to properly
fit around the leg of the bender. Verify that the trap
plate is 3.06" (77.7 mm) below the leveling screws.
If necessary, loosen the two hex head screws and
adjust the distance. Retighten the screws.
the "Additional Bending Instructions" section of this
manual.
bending position.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070